Numerical Evaluation of Post-Earthquake Stability and Rehabilitation of Mountain Trails ‘Unnat Goreto’ in Gorkha and Rasuwa Districts, Nepal

Authors

  • Bikash Adhikari Department of Environmental Science and Engineering, Kathmandu University, Nepal Author https://orcid.org/0000-0002-2179-0246
  • Ram Chandra Tiwari Department of Civil Engineering, Institute of Engineering, Pulchowk Campus, Tribhuvan University, Lalitpur, Nepal Author
  • Aanchal Tiwari Department of Civil Engineering, Institute of Engineering, Pulchowk Campus, Tribhuvan University, Lalitpur, Nepal Author

DOI:

https://doi.org/10.64862/ajeg.2026.301.01.270

Keywords:

Mule track, Stability analysis, Safety factor, Finite Element Method, Earthquake

Abstract

This study investigates the stability of mountain trails (locally known as Unnat Goreto) that were rehabilitated in highly affected communities of Gorkha and Rasuwa Districts following the 2015 Mw 7.8 Gorkha Earthquake in Nepal. The stability of critical trail sections was analyzed using the 2D Finite Element Method (FEM) in Rocscience Phase2 software. This paper presents the stability assessment of one representative critical section from each trail, both rehabilitated in 2017. Stability was evaluated under both best- and worst-case scenarios using the Strength Reduction Method (SRM) based on the Mohr–Coulomb and Hoek–Brown failure criteria.Results indicate that the slope is stable under static conditions and marginally safe under a pseudo-static horizontal seismic coefficient (EQx) of 0.1g, but becomes unstable under higher seismic loading for the trail in Gorkha District. In contrast, the trail in Rasuwa District shows relatively higher stability. The soil-bioengineering slope stabilization techniques applied immediately above and below the trail sections significantly enhance the factor of safety. Additionally, dry stone walls constructed below the trail as retaining structures contribute substantially to slope stability, with their effectiveness varying by wall type (Type 1-3). The analysis also incorporates the influence of mule loads, track components, and stabilization measures. Overall, the study emphasizes the importance of integrating geotechnical design with bioengineering and appropriate structural interventions to ensure the long-term stability and functionality of rehabilitated mountain trails in seismically active, mountainous regions.

References

Cai, M., Kaiser, P. K., Uno, H., Tasaka, Y., and Minami, M. (2004). Estimation of rock mass deformation modulus and strength of jointed hard rock masses using the GSI system. International Journal of Rock Mechanics and Mining Sciences, 41(1), 3–19. https://doi.org/10.1016/S1365-1609(03)00025-X

Charles, A., Flink, K., Olka, K., and Searns, R. M. (2001). Trails for the Twenty-First Century: Planning, Design, and Management Manual for Multi-Use Trails (2nd ed.). Rails-to-Trails Conservancy. https://doi.org/10.2307/jj.41003685

Deere, D., and Miller, R. (1966). Engineering classification and index properties of rock (Technical Report No. AFNLTR-65-116). Air Force Weapons Laboratory, Albuquerque, NM. https://doi.org/10.21236/ad0646610

Department of Local Infrastructure Development and Agricultural Roads (DoLIDAR), Government of Nepal (GoN). (2010). Revised norms: Working norms for agricultural and rural roads.

DoR (2007). Department of Roads Government of Nepal. Roadside Geotechnical Problems: A Practical Guide to Their Solution.

Goodman, R. E., Taylor, R. L., and Brekke, T. L. (1968). A model for the mechanics of jointed rock. Journal of the Soil Mechanics and Foundations Division, ASCE, 637–659. https://doi.org/10.1061/JSFEAQ.0001133

Griffiths, D.V, and Lane, P.A. (1999). Slope stability analysis by finite elements. Géotechnique, 49(3), 387–403. https://doi.org/10.1680/geot.51.7.653.51390

Hoek, E., and Diederichs, M.S. (2006). Empirical estimation of rock mass modulus. International Journal of Rock Mechanics and Mining Sciences, 43, 203–215. https://doi.org/10.1016/j.ijrmms.2005.06.005

Krahenbuhl, J., and Wagner, A. (1983). Survey, design, and construction of trail suspension bridges for remote areas. SKAT, Swiss Center for Appropriate Technology, St. Gallen, Switzerland.

Marinos, P., and Hoek, E. (2000). GSI: A geologically friendly tool for rock mass strength estimation. In Proceedings of the GeoEng2000 International Conference on Geotechnical and Geological Engineering (pp. 1422–1446). Technomic Publishers, Lancaster.

Matsui, T., and San, K. C. (1992). Finite element slope stability analysis by shear strength reduction technique. Soils and Foundations, 32(1), 59–70. https://doi.org/10.3208/sandf1972.32.59

Minnesota Guideline (2006). Minnesota Department of Natural Resources. Trail Planning, Design, and Development Guidelines: Shared Use Paved Trails, Natural Surface Trails, Winter-Use Trails, Bikeways. Trails and Waterways, Minnesota Department of Natural Resources.

Pal, S., Kaynia, A. M., Bhasin, R. K., and Paul, D. K. (2012). Earthquake stability analysis of rock slopes: A case study. Rock Mechanics and Rock Engineering, 45, 205–215. https://doi.org/10.1007/s00603-011-0145-6

Patton, F. (1966). Multiple modes of shear failure in rock. In Proceedings of the 1st Congress of the International Society for Rock Mechanics, Lisbon, Vol. 1, pp. 509–513.

Popescu, M. E. (2001). A suggested method for reporting landslide remedial measures. IAEG Bulletin, 60(1), 69–74. https://doi.org/10.1007/s100640000084

Rocscience (2012). Phase2: A 2D Finite Element Program for Calculating Stresses and Estimating Support around Underground Excavations. Geomechanics Software and Research, Rocscience Inc., Toronto, Canada. Available at: www.rocscience.com

Trail Design Guidelines. (2009). Regional Trails, Natural Areas and Developed Parks. PP&R Trail Guidelines Coordination Team, Portland Parks & Recreation, Portland, Oregon.

USDA (1984). U.S. Department of Agriculture Standard Specifications for Construction of Trails. USDA Forest Service Engineering Staff.

Downloads

Published

2026-06-30

How to Cite

Numerical Evaluation of Post-Earthquake Stability and Rehabilitation of Mountain Trails ‘Unnat Goreto’ in Gorkha and Rasuwa Districts, Nepal. (2026). Asian Journal of Engineering Geology, 3(1), 1-16. https://doi.org/10.64862/ajeg.2026.301.01.270

Most read articles by the same author(s)

Similar Articles

71-80 of 188

You may also start an advanced similarity search for this article.