Engineering Geological Characterization and Mapping of Aleta Wondo Town for Urban Development in Southern Ethiopia

Authors

  • Deginet Tesfaye Youkamo Bonga University, Kaffa, Bonga, Ethiopia Author
  • Ephrem Getahun Gure Arba Minch University, Arba Minch, P.O. Box 21, Ethiopia Author https://orcid.org/0000-0002-9527-4770

DOI:

https://doi.org/10.64862/ajeg.2026.301.02.317

Keywords:

Engineering geological map, Rock Mass Rating (RMR), Residual soil, Ethiopia

Abstract

Aleta Wondo town, located in the Sidama Regional State of Ethiopia, lacks comprehensive geotechnical information on its ground conditions. The soils and rocks of the area have not been comprehensively characterized, despite the presence of geotechnical and geo-environmental challenges, including settlement, landslides, and groundwater problems. Comprehensive information on the types, characteristics, and distribution of underlying soils and rocks is essential for the safe and economically feasible construction of engineering structures. The primary objective was to characterize the geological and geotechnical properties of the study area through engineering geological investigations of soil and rock and to prepare a detailed multipurpose engineering geological map. Field investigations and laboratory testing were conducted to achieve this objective. Laboratory tests included natural moisture content, Atterberg limits, grain-size distribution, free swell, and shear strength. Seven traverses were conducted across the town to document exposures along road and river cuts, quarry sites, stream channels, and slope cuts. Discontinuity characteristics were measured and recorded, and Schmidt hammer tests were conducted on exposed rock surfaces. The laboratory and field results were used to classify the soils and rocks for engineering purposes. The Unified Soil Classification System (USCS), British Standard System (BSS), Rock Mass Rating (RMR), and unconfined compressive strength were used for classification. According to the USCS, the soils are classified as CL, representing inorganic clays of low to medium plasticity, and MH, representing inorganic and elastic silts. According to the BSS, the soils are classified as compressible silt and medium-plasticity inorganic clay. Based on RMR, unconfined compressive strength, and degree of weathering, the rocks are classified as good basalt with slight weathering and very high strength, good ignimbrite with slight weathering and high strength, and poor ignimbrite with high weathering and very low strength.

References

AASHTO (2014). Standard Specifications for Transportation Materials and Methods of Sampling and Testing and 2014 AASHTO Provisional Standards (34th ed.). American Association of State Highway and Transportation Officials (AASHTO). 1023p.

Arnold, V. (2001). Soil Mechanics. Standard Publishers Distributors, Delft University of Technology.

Arora, K. R. (2008). Soil Mechanics and Foundation Engineering (Geotechnical Engineering): In SI Units. Standard Publishers, New Delhi.

ASTM (2018). Standard test methods for liquid limit, plastic limit, and plasticity index of soils (D4318-10). ASTM International. https://doi.org/10.1520/D4318-10

ASTM (2023). Standard test methods for specific gravity of soil solids by the water displacement method (ASTM D854-23). ASTM International. https://doi.org/10.1520/D0854-23

Ayalew, A., Balabathina, V. N., Birhane, G., Shano, L., Demise, T., and Tadese, A. (2022). Engineering geological characterization of soils and rocks in Arba Minch Town, Southern Ethiopia: Implication for building cracks and road failures. International Journal for Modern Trends in Science and Technology, 8(7), 102–117. https://doi.org/10.46501/IJMTST0807017

Ayele, A., Woldearegay, K., and Meten, M. (2022). Multichannel analysis of surface waves (MASW) to estimate the shear wave velocity for engineering characterization of soils at Hawassa town, Southern Ethiopia. International Journal of Geophysics, Article ID 7588306. https://doi.org/10.1155/2022/7588306

Bell, F. G. (2007). Engineering Geology (2nd ed.). Butterworth-Heinemann, Elsevier.

Berhane, G. (2010). Engineering geological soil and rock characterization in the Mekelle Town, Northern Ethiopia: Implications to engineering practice. Momona Ethiopian Journal of Science, 2(2), 64–86.

Bieniawski, Z. T. (1989). Engineering Rock Mass classifications: A complete manual for engineers and geologists in mining, civil, and petroleum Engineering. John Wiley & Sons.

Bowles, J.E. (1996). Engineering properties of soils and their measurement. (4thed.) McGraw-Hill, New York.

Chemeda, Y. C. (2020). Engineering geological investigation of Adama town: Implication to engineering practice. Ethiopian Journal of Science and Sustainable Development, 7(2), 103–116. https://doi.org/10.20372/ejssdastu:v7.i2.2020.281

Chen, F.H. (1988). Foundations on expansive soils (2nd ed.). Developments in Geotechnical Engineering, 54. Elsevier.

Clayton, C. R. I. (1995). The standard penetration test (SPT): Methods and Use. CIRIA Report 143. Construction Industry Research and Information Association, London.

Debebe D. (2011). Investigation on some of engineering characteristics of soils in Adama town, Ethiopia ( Msc. Thesis, Addis, Addis Ababa University). http://etd.aau.edu.et/handle/12345678/3082

Deere, D. U., and Deere, D. W. (1988). The rock quality designation (RQD) index in practice. In L. Kirkaldie (Ed.), Rock classification systems for engineering purposes (ASTM STP 984, pp. 91–101). ASTM International. https://doi.org/10.1520/STP48465S

Derbyshire, E., 2001. Geological hazards in loss terrain, with particular reference to the loess regions of China. Earth-Science Rev. 54, 231–260. https://doi.org/10.1016/ S0012-8252(01)00050-2

Ganole, K., (2010). GIS Based Surface Irrigation Potential Assessment of River Catchments for Irrigation Development in Dale Woreda Sidama Region. M.Sc. Thesis, Haramaya University. Available at: https://cgspace.cgiar.org/bitstreams/483328b2-7fe1-4615-9ae9-8b012f1dc00c/download

Gure, E. G., Weldearegay, K., and Birhane, G. (2013). Engineering geological and geotechnical appraisal of Northern Mekelle town, Tigray, Northern Ethiopia. American Scientific Research Journal for Engineering, Technology, and Sciences, 5(1), 23–56. Available at: https://asrjetsjournal.org/American_Scientific_Journal/article/view/532

Holtz, R. D., and Kovacs, W. D. (1981). An introduction to geotechnical engineering. Prentice-Hall, Englewood Cliffs, New Jersey.

Holtz, W. G., and Gibbs, H. J. (1956). Engineering properties of expansive clays. Transactions of the American Society of Civil Engineers, 121(1), 641–663. https://doi.org/10.1061/TACEAT.0007325

Hroch, T., Megerssa, L., Buriánek, D., Verner, K., Martínek, K., Mihret, Y., Janderková, J., Šíma, J., Kryštofová, E., Gebremariyam, H., Tadesse, E., Legesse, F., Valenta, J., Pécskay, Z., and Hejtmánková, P. (2018). Explanatory notes to the thematic geoscientific maps of Ethiopia at a scale of 1:50,000, Map Sheet 0638-A2 Leku. Czech Geological Survey, Prague.

Hunde, B. (2014). Investigation on some of engineering properties of soils found in Ambo Town, Ethiopia, Ph.D. Thesis. Addis Ababa University. Available at: http://etd.aau.edu.et/handle/12345678/2402

Kaniraj, S. R. (1988). Design aids in soil mechanics and foundation engineering. Tata McGraw-Hill Publishing Company, New Delhi.

Matula, M. (1981). Rock and soil description and classification for engineering geological mapping: Report by the IAEG Commission on Engineering Geological Mapping. Bulletin of the International Association of Engineering Geology, 24, 235–274. https://doi.org/10.1007/BF02595273

Munsell A. H. (2000). Munsell soil color charts (Year 2000 revised washable ed.). Munsell Color, New Windsor, New York.

Murthy, V. N. S. (2003). Geotechnical engineering: Principles and practices of soil mechanics and foundation engineering. Marcel Dekker, New York.

Mussie, M. (2007). Groundwater Circulation and Hydrochemistry of the Corridor (Upper Gidabo River and Lake Awassa Catchments), Sidama Zone, Snnprs. M.Sc. Thesis, Addis Ababa University. Available at: http://10.90.10.223:4000/handle/123456789/7379

Osuolale, O. M., Falola, O. D., and Ayoola, M. A. (2012). Effect of pH on geotechnical properties of laterite soil used in highway pavement construction. Civil and Environmental Research, 2(10), 23–28. https://www.iiste.org/Journals/index.php/CER/article/view/3536

Palmström, A. (1982). The volumetric joint count: A useful and simple measure of the degree of rock mass jointing. In Proceedings of the 4th International Congress of the International Association of Engineering Geology, pp. 221–228.

Prakash, K., and Sridharan, A. (2004). Free swell ratio and clay mineralogy of fine-grained soils. Geotechnical Testing Journal, 27(2), 220–225. https://doi.org/10.1520/GTJ10860

Price, D. G. (2008). Engineering geology: Principles and practice. Edited and compiled by M. H. de Freitas. Springer, Berlin, Heidelberg. https://doi.org/10.1007/978-3-540-68626-2

Raj, P. P. (2012). Soil mechanics and foundation engineering. Dorling Kindersley (India) Pvt. Ltd., New Delhi.

Rich, C. I. (1968). Mineralogy of soil potassium. In V. J. Kilmer, S. E. Younts, and N. C. Brady (Eds.), The role of potassium in agriculture (pp. 79–96). American Society of Agronomy, Crop Science Society of America, and Soil Science Society of America. https://doi.org/10.2134/1968.roleofpotassium.c5

Seed, H. B., Woodward, R. J., Jr., and Lundgren, R. (1962). Prediction of swelling potential for compacted clays. Journal of the Soil Mechanics and Foundations Division, 88(3), 53–87. https://doi.org/10.1061/JSFEAQ.0000431

Wahid, M. G. (2007). Suitability of Ground condition for building and road in Hawassa town, Southern Ethiopia. MSc Thesis. Addis Ababa University, Ethiopia, 97p.

Wang, H, Lin, H., and Cao, P. (2017). Correlation of UCS rating with Schmidt hammer surface hardness for rock mass classification. Rock Mechanics and Rock Engineering, 50(1), 195–203. https://doi.org/10.1007/s00603-016-1044-7

Yasin, K., (2002). Hydrogeology of upper Gidabo river catchment, Southern Ethiopia, M.Sc. Thesis. Addis Ababa University, Ethiopia.

Yismaw, A., Besufikad, A., Dure, T., Ersido, A., Kebede, E., Wondfraw, T., and Ababa, A. (2012). Geology, geochemistry and gravity survey of Megalo Map Sheet. Geological Survey of Ethiopia, Basic Geoscience Mapping Directorate.

Downloads

Published

2026-06-30

Data Availability Statement

The datasets supporting the findings of this study are available from the corresponding author upon reasonable request via email.

How to Cite

Engineering Geological Characterization and Mapping of Aleta Wondo Town for Urban Development in Southern Ethiopia. (2026). Asian Journal of Engineering Geology, 3(1), 17-36. https://doi.org/10.64862/ajeg.2026.301.02.317

Similar Articles

81-90 of 229

You may also start an advanced similarity search for this article.